THOR Class C Series - Exterior

LEVELING JACKS AND SLIDEOUT SYSTEMS
91THOR MOTOR COACH | MADE TO FIT
10
NOTE: Always check and remove debris on
the roof of the slideout and awnings before
retracting.
NOTE: Always perform an interior and
exterior visual inspection before leaving the
campground or traveling.
2. Turn the battery disconnect switch ON.
3. Locate the slideout operating switch and:
a. Hydraulic slideout: press and hold the slideout operating switch until the slideout room
is fully extended. en release switch.
b. Electric slideout: extend the slideout out and hold the switch for an additional 3-5
seconds (this allows the slide motors to amp out).
Note: ere is a 30 second delay feature on the tilt a bed rear bed slideout (if so equipped),
to allow time to raise the head of the bed.
4. Aer the room is fully extended, immediately release the button. Failure to do so could
cause damage to the slide assembly.
Retracting the Slideout
Use the same safety precautions as previously stated for extending the slideout, and:
1. Be sure there are no obstructions on the oor of the coach or in the path of the room as it
is coming in.
2. Ensure there is no visible dirt or debris in the track of the slideout or under it. Trapped
dirt or debris could cause damage to your carpet or oor.
3. Locate the slideout operating switch and:
a. Hydraulic slideout: press and hold the switch until the room is completely retracted,
then immediately release the switch.
b. Electric slideout: Fully retract the room, and hold the switch for an additional 3-5
seconds (until the motors amp out). en immediately release the switch.
4. Install the slideout locking devices (if so equipped.).