ELECTRICAL SYSTEMS
59THOR MOTOR COACH | MADE TO FIT
6
A 30 amp or 50 amp shore line power cord is provided to connect the motorhome to a
grounded 120 volts AC power source. Depending upon your brand and model, the shore line
power cord will either be permanently mounted to a motorhome interior compartment or
detachable. When hooking up to the external power source:
1. Turn OFF the load center main 120 volts AC circuit breaker
2. Carefully extend the entire length of the shore line power cord (approximately 25’-35’)
from the electric cable hatch to the external power source
3. Plug the shore line power cord into the receptacle. Be sure all the prongs are properly
plugged into the receptacle
4. Turn the load center main circuit breaker back ON
When you are ready to leave, reverse the shore line power cord connection process. Use care
to prevent damaging the electrical connection pins when connecting or disconnecting the
shore line power cord. Grasp the plug to remove the shore line power cord from the outlet; do
not unplug it by pulling on the cord.
Maintenance
Inspect the shore line power cord for cuts, cracks, and worn insulation; replace it immediately
if these symptoms are noticed.
Monitor Panel
Items that may typically be found on the monitor panel include (inclusion and location will
vary by model year, brand and model):
• Lighted holding tank level indictors and switch(es)
• Lighted battery level switch and indicator
• Lighted water heater switches (electric & propane gas)
• Lighted water pump switch
• Generator start / stop switch
NOTE: Monitor panel design, features, and
functions vary depending on model year,
make, and model. Motorhomes equipped
with multiplex systems have other features
integrated into the controller. For further
assistance, contact your selling dealer or
TMC Customer Care at (877) 855-2867.
To Next Page
Loading...
