THORENS TD 146 User Manual

III. Electrical connections and installation
1. The turntable may
be powered from
any line voltage by
using the
appropriate
THORENS AC
Adapter (6).
Verify that the line
voltage of the
adapter delivered
with your turntable
corresponds to the
line voltage
intended for use.
2. The stereophonic
signal cable is
terminated with
RCA (Cinch)
phono plugs, coded
as follows: L for
left channel, and R
for right channel.
They are to be
connected to the
appropriate phono
input of an
amplifier or
receiver.
The separate wire
should be attached
to the grounding
screw at the chassis
of the amplifier. It
establishes a
common ground
and thus prevents
hum introduction
(Figure 8).

THORENS TD 146 Specifications

General

Drive System	Belt drive
Speeds	33 1/3, 45 RPM
Platter	Aluminum die-cast
Tonearm	TP 16
Automatic Function	Semi-automatic
Effective length	230 mm
Effective mass	16.5 g
Overhang	15 mm
Wow and flutter	0.05%
Motor	16-pole synchronous motor