THORENS TD-150 - VI. Assembling the outer 12 turntable platter on the inner turntable; VII. Cartridge installation and connections; Cartridge installation

VI. Assembling the outer 12°’ turntable platter on the inner
turntable
© Remove the stylus force calibration plate (part S 808-225), delivered with each TD-150 AB and
A models, from the unit plate.
@ Carefully centre the outer turntable platter on the inner platter and the rubber mat on top of them,
© The central adapter (part S 800-522) is packed on the inner turntable. It may be installed in two
inverse positions on the centre pin: for normal or for large hole records.
Important notice. The motor, its spindle and the motor pulley are engineered to very close tole-
rances. As a delicate and high precision instrument, it should be protected against any shock or
strain when installing or forwarding the turntable. Take particular care when removing or
assembling the outer turntable on the inner turntable platter
Damages on these parts caused by accident will invalidate our warranty.
VII. Cartridge installation and connections
Ifa cartridge h
plug-in shell,
en purchased which has been professionaly premounted into the Thorens
sregard the following.
0 Cartridge installation
The aluminium plug-in shell offers enough space and the necessary mounting hardware to suit any
standard pick-up cartridge.
The specific mounting instructions furnished by the cartridge manufacturers should be followed
EXCEPT that the screws delivered with the TD-150 AB and A turntables must be used. (The mount-
°