Rev D Mar 2020
Page 42
Chapter 6 Software Reference
link. The Move and Jogging parameters described previously are good examples of
settings that can be altered and then persisted in the driver for use in absence of a
PC. To save the settings to hardware, check the ‘Persist Settings to Hardware’
checkbox before clicking the ‘OK button.
6.3.2 Panel Tab
Fig. 6.4 Piezo Motor Driver K-Cube - Panel Settings
Joystick Settings
The joystick is sprung such that when released it returns to it’s central position. In this
central position the motor is stationary. As the joystick is moved away from the center,
the motor begins to move; the speed of this movement increases as the deflection is
increased. Bidirectional control of motor moves is possible by moving the joystick in
both directions.
Mode
Velocity Control - Deflecting the joystick starts a move with the velocity
proportional to the deflection. The maximum velocity (i.e. velocity corresponding
to the full deflection of the joystick wheel) is set in the Max Step Rate parameter.
Position Jogging - Deflecting the joystick initiates a jog move, using the
parameters specified by the Move/Jogs tab. The joystick must be released before
another jog move can be initiated.
Caution
The current settings are always saved to the unit (persisted) when the unit is
powered down.
To Next Page
Loading...
