Rev K Jan 2020
Page 50
Chapter 7 Software Reference
SetEncPosControlParams Sets the encoder position control parameters for
encoder equipped stages.
SetEncPosCorrectParams Sets the encoder position correction parameters for
encoder equipped stages.
SetHomeParams Sets the homing sequence parameters.
SetHWLimSwitches Sets the limit switch configuration settings.
SetJogMode Sets the jogging button operating modes.
SetJogStepSize Sets the jogging step size.
SetJogVelParams Sets the jogging velocity profile parameters.
SetMotorParams Sets the motor gearing parameters.
SetPhaseCurrents Sets the coil phase currents.
SetPositionOffset Sets the motor position offset.
SetPotParams Sets the velocity control potentiometer parameters
(Cube drivers).
SetRelMoveDist Sets the relative move distance.
SetStageAxisInfo Sets the stage axis parameters.
SetTriggerParams Sets the move triggering parameters.
SetVelParams Sets the velocity profile parameters.
ShowSettingsDlg Display the GUI Settings panel.
StartCtrl Starts the ActiveX Control (starts communication
with controller)
StopCtrl Stops the ActiveX Control (stops communication
with controller)
StopImmediate Stops a motor move immediately.
StopProfiled Stops a motor move in a profiled (decelleration)
manner.
Properties
APTHelp Specifies the help file that will be accessed when the
user presses the F1 key. If APTHelp is set to 'True',
the main server helpfile APTServer will be launched.
DisplayMode Allows the display mode of the virtual display panel
to be set/read.
HWSerialNum specifies the serial number of the hardware unit to
be associated with an ActiveX control instance.
To Next Page
Loading...
Need help?
General
