THORLABS PM100A - Page 52

6.5 SCPI Commands
50
6.5.2.4 INPut subsystem commands
Command
Description
INPut
[:PDIode]
:FILTer
[:LPASs]
[STATe] {OFF|0|ON|1}
[STATe]?
Sets the bandwidth of the photodiode input stage
Queries the bandwidth of the photodiode inut stage
:THERmopile
:ACCelerator
[STATe] {OFF|0|ON|1}
[STATe]?
:TAU {MINimum|
MAXimum|DEFault|
<numeric_value>[s]}
:TAU? [{MINimum|
MAXimum|DEFault}]
Sets the thermopile accelerator state
Queries the thermopile accelerator state
Sets thermopile time constant
(0-63%)
in s
Queries the thermopile time constant
(0-63%)
in s
:ADAPter
[:TYPE] {PHOTodiode|
THERmal|PYRo}
[:TYPE]?
Sets default sensor adapter type
Queries default sensor adapter type
Commands for PM100D / PM100USB only