THUNDER TIGER KT8 - Transmitter Controls

СО under
Tiger
TRANSMITTER CONTROLS
1. Transmitter Antenna: Straighten up the antenna before operating the model.
2. Battery Level Indicator: Three LEDs indicate the battery voltage level. If the Red LED
flashes, please replace the batteries.
3. HI/LO Throttle ATV (Adjustable Travel Volume): Provides the function to let you
independently preset the maximum travel of the throttle servo either side (high / low) of
neutral.
4. Servo reversing switches: To reverse the servo's rotation direction at the flip of the
Switch. The reversing switches are recessed into the transmitter to prevent accidental
operation.
5. Steering Trim: Adjusts the steering in small increments or decrements to run the model
straight.
6. Throttle Trim: Adjusts the throttle in small increments or decrements to shift the neutral
position.
7. Steering DIR (Dual Rates): Push this lever left or right to adjust the amount of the steering
dual rate. Right to increase dual rate amount and left to decrease the amount.
8. AUX Ch Button: Provides an extra function for the control of the model.
9. External Charging Jack: For rechargeable NiCd/NiHM battery pack on the transmitter
only.
10. 2.4GHz binding SW: The Binding SW button is located on the back of the 2.4GHz
transmitter. For additional details, please refer to the "Binding" setting procedure (Page 7).
11. Steering Wheel: Controls the steering of the model.
12. Power Switch: Sliding to turn the transmitter on or off.
13. Throttle Trigger: pulled or pushed to control the movement of the model.
14. Steering Tension Adjustment: Use a Phillip type screwdriver to tighten or loosen the
tension of the steering wheel.
15. Battery Cover: Slide cover to install or remove batteries.