THUNDER TIGER KT8 - Fail Safe (F;S) Function Setting >8

FAIL SAFE (F/S) FUNCTION SETTING
ACE RC COUGAR 2.4GHz RIC system features a built-in Failsafe function to
automatically set a servo command if the receiver loses the signal from transmitter due
to interference. For safety, we strongly recommend to active the FAILSAFE function on
your Cougar R/C system.
Setting up the Failsafe (F/S) Function:
a. After binding the transmitter and receiver, you can continually set up the F/S function. Turn on the transmitter
power and then receiver power.
b. Press and hold the "Binding SW" button on the receiver for 10 seconds. The LED will start flashing GREEN on
the receiver.
ДУ CAUTION: Do not release the "Binding SW’ button оп the receiver until STEP C is completed.
c. Move and hold the throttle trigger to the position you want the control to be in if a failsafe condition should
occur, First, keep steering wheel at neutral position | steering servo at neutral position) . To set up F/S
function with the throttle servo position at "Brake", first push the trigger to the brake position and hold. To set
up F/S function with servo position at "Neutral", keep the trigger at neutral position
NOTE:
Always set the throttle trigger to neutral or full brake position and steering servo to neutral position in
case of any unexpected control error!
Factory pre-settings for RC car F/S function are :
Wil Electric Car- Steering servo at neutral, throttle at neutral.
W Nitro Car- Steering servo at neutral, throttle at iddle.
d. After the Step C, release the "Binding SW" button on the receiver first and then the throttle trigger. The LED
turns to solid "RED" and then back to solid "GREEN" indicating the F/S function has now been activated.
e. Test by turning off your transmitter and watching the servo failsafe position activate.
F/S at "Neutral": To check the fail safe is working properly, by moving the throttle trigger to the full forward
(full brake), hold this position and then turn off the transmitter. The F/S function should move the throttle servo
to "Neutral" position and the steering servo to "Neutral" position.
FIS at "Brake": To check the fail safe is working properly, by keeping the throttle trigger at neutral and then
turn off the transmitter. The F/S function should move the throttle servo to "Brake" position and the steering
servo to "Neutral" position
f. If the F/S function fails or need to change the F/S hold position, repeat the steps a) ~e). After the F/S is
completed, you can start normal operation.
A CAUTION:
ALWAYS reset FAILSAFE function after binding your transmitter & receiver.