ThyssenKrupp Access Citia User Manual

1
Installation and Service Manual
Alternating Current Systems (A/C)
Stair Lift
ThyssenKrupp Access
Part #470269
Rev. C
Warning!
STRICT ADHERENCE TO THESE INSTALLATION INSTRUCTIONS is required and will promote the safety of those
installing this product, as well as those who will ultimately use it for the purpose intended.
Any deviation from these instructions will void the LIMITED WARRANTY that accompanies the product.
Additionally, any party installing the product who deviates from the INSTALLATION INSTRUCTIONS shall be
taken to agree to INDEMNIFY, SAVE AND HOLD HARMLESS the manufacturer from any and all loss, liability or
damage, including attorneys fees, that might arise out of or in connection with such deviation.
ThyssenKrupp
Citia and

ThyssenKrupp Access Citia Specifications

General

Type	Stairlift
Speed	0.15 m/s
Foldable	Yes
Swivel Seat	Yes
Safety Sensors	Yes
Remote Control	Yes
Battery Backup	Yes
Track Type	Single Rail
Seat Width	460 mm

Summary

PRELIMINARY CHECKS

INSTALLATION SITE REQUIREMENTS

Specifies electrical and physical site requirements for installation.

TOOLS REQUIRED

Lists all tools needed for proper installation of the stair lift.

SHIPMENT

Details components included in the shipment and verification steps.

TYPICAL COMPONENTS

DETERMINE TRACK INSTALLATION SIDE

Guidance on choosing the correct side of the stairway for track installation.

TRACK INSTALLATION PREPARATION

INSTALL MOUNTING HARDWARE

Attaching brackets to the staircase treads using T-bolts.

INSTALL SPLICE BARS

Joining track sections with splice bars for a continuous track.

TIME THE GEAR RACK

Adjusting gear rack position for proper track alignment and engagement.

TRACK AND CHASSIS INSTALLATION

MOUNT TRACK TO STAIRCASE

Securing the assembled track to the stair treads for stability.

INSTALL CHASSIS ASSEMBLY INTO TRACK

Placing the stair lift chassis onto the installed track.

ELECTRICAL AND SEAT INSTALLATION

INSTALL JUNCTION BOX

Wiring the electrical junction box for power connection to the unit.

INSTALL THE SEAT

Attaching the seat assembly to the stair lift chassis.

COMPLETION PROCEDURES

COMPLETION CHECKLIST

Verifies all operational features before the stair lift is released for use.

BEFORE LEAVING THE JOBSITE

Tasks to be completed before departing the installation site.

E.T.L. REQUIREMENTS

SERVICE INFORMATION

GENERAL SPECIFICATIONS

Provides key performance and physical specifications of the stair lift.

STANDARD EQUIPMENT

Lists the standard components and features included with the unit.