01/09/2014 Orion Optional Installation Manual
11
4.1.1. Verifying installation and speed programming
Programming the telephone line
Raise the local telephone.
Key in 0 # from the local telephone to enter into
programming.
After having heard 3 short tones, key in 6 6 0 .
Hang up and key in 0 # from the local telephone to
exit from programming.
Programme a telephone number to request assistance:
Raise the local telephone.
Key in 0 # from the local telephone to enter into
programming.
Key in 2 1 0 1 1 2 <telephone number to which the call
for assistance arrives> #
Hang up and key in 0 # from the local telephone to
exit from programming.
Record the elevator identification message (max. 22
seconds). This must include all information on the
system location.
Key in 7 1 0 1 and read out the message (max 22
seconds). At the end of the message, hang up.
To hear it again: 7 2 0 1
Hang up and key in 0 # from the local telephone to
exit from programming.
Make an outside call to verify that the phone line is
working
Key in 0 # from the local telephone to enter into
programming.
Key in 0 and comprise the telephone number to test.
To interrupt the call, hang up and key in
0 # from the
local telephone to exit from programming.
Note: when you raise the local telephone, if you hear a whistle from the hands free, adjust
speaker sensitivity.“Errore. L'origine riferimento non è stata trovata.”.
Note: It is possible to carry out the programming described above without having to exit
and re-enter into programming each time
4.1.2. Verifying alarm procedure
Causing alarm procedure
Press the aid request button in the cabin and hold for
more than 2 seconds. Wait for the alarm to turn on.
Answering and resetting the alarm
Answer from the number called and:
Press 5 to listen to the message or wait a few
seconds.
To Next Page
Loading...
Need help?
General
