01/09/2014 Orion Optional Installation Manual
13
After programming, to make the settings effective, you
will need to exit the programming status. To this end,
use the same procedure as to access programming:
Raise the local telephone. You will hear the signal
inviting you to make a selection.
Key in <installer or operator key word> # . For
example, if the key word set by the manufacturer (0)
has not been changed, key in 0 # .
Establish connection with HANDS FREE directly.
4.2.2. Basic programming
The basic programming to be carried out on the device,
is as follows:
choice of telephone line type used (landline)
programming of telephone numbers for each type of
alarm
recording of identification message
clock programming
enabling the flat battery warning alarm
adjusting hands free and message volume
(optional).
Type of telephone line
Allows you to programme the type of line used.
Key in 0 # from the local telephone to enter into
programming.
Key in 660
Hang up and key in 0 # from the local telephone
to exit from programming.
ATTENTION! Ensure jumper JP8 is positioned towards the outside.
Programming of telephone numbers
Up to a maximum of 12 telephone numbers can be
programmed in.
To programme a telephone number to request
assistance:
Raise the micro telephone;
Key in
0 # from the local telephone to enter into
programming.
Press 2 1.
Enter the position of the telephone number in the
table of 12 numbers available, from 01 to 12;
Enter a figure relative to the event:
- “1” Assistance request button;
- “2” Technological and diagnostic alarm (flat
battery)
- “3” Periodic Automatic Test call
Enter a figure relative to the type of receiver:
To Next Page
Loading...
Need help?
General
