ThyssenKrupp orion Installation Manual

01/09/2014 Orion Optional Installation Manual
2
1. 'EVO' door-opener
1.1. Preliminary inspection
 Check that the door is in
g
ood condition.
 Check that the door movement is uniform and that the hinges are not
too loose.
 Check that the door is plumb and in line with the horizontal upright to
which the sliding guide must be fixed.
 Dismantle and remove the door suspension (figure 1A).
 Disconnect and remove the return spring to close the door (figure 1B).
Figure 1 - Removal of the spring (A)
and the suspension (B) from the
door
1.2. Assembly of the mechanical components
 Remove the protective cover and fix the automation to the wall, in
accordance with the measurements given in figure: refer to the hinge
axis using M6x40 screws with relative nuts and washers to fix the door-
opener.
 Pierce the guide [C] and fix to the door using M5x10 screws.
 In the event of an aluminium door, pierce and thread M5 the door.
Figure 2 - Fixing the door-opener
Figure 3 - Fixing the guide above the
door
A
A
B

ThyssenKrupp orion Specifications

General

Brand	ThyssenKrupp
Model	orion
Category	Lifting Systems
Language	English