Tiandy S6 - Chapter 1 Precautions

3
Chapter 1 Precautions
In order to avoid danger and operate the products correctly, please read this manual carefully
before installation.
The precaution contains two parts “Warning” and “Note” as following:
Warnings alert the user to avoid
the potential risk of death or serious
injury
Cautions alert the user to avoid the
potential risk of injury or property
damage
Warning:
● Please use AC 24V power supply meeting SELV(Safety Extra Low Voltage) and in accordance with
IEC60950-1 compliance with Limited Power Source
● Please contact nearest distributor or service center if the products don’t work properly, do not
remove or modify the device in any way (unauthorized modification or repair problems caused by
your own risk).
● Please don’t expose the indoor product to rain or moisture.
● The installation should be performed by professional staff, and comply with local regulations.
● Please mount easily using power protection device in the wire installation.
● Please make sure the connection can withstand at least 50 Newtons vertically downward pull.
Note:
● Please check if the power supply is correct.
● In transportation and storage process, please prevent stress, severe vibration and immersion to
avoid any damage
● Please don’t touch the image sensor and housing directly, if necessary, please gently clean with
alcohol dampened.
● Please don’t touch the cooling components directly, in order to avoid burns.
● Please don’t focus aligned glare (such as lighting, sunlight, etc.), otherwise it will easily lead to
too bright or pull light phenomena, also affect the image sensor life.
● The laser beam may burn the image sensor, so when it is used, please don’t expose the image
sensor in laser beam.
● Please don’t put it in the damp, dusty, extreme heat, extreme cold, strong electromagnetic
radiation places.
● Please make sure the installation location keep enough distance from the electromagnetic