Satellite List
1. Satellite list is on the left side of the window. Press
PR+, PR- keys to select the satellite up or down. Press
OK key to select and mark, and you can press OK key
again to cancel the selection and the mark.
2.1Installation
Press keys to select between Motor
Antenna and Fixed Antenna.
2. Installation
1. Press OK key or key to pop up the "Input
Password" dialogue, you can not enter into the menu
unless the correct password is inputted. The default
password is "0000".
2. Press PR+, PR- keys to move the cursor up or
down.
1.6 System Recovery
Move cursor to the System Recovery item, and press
OK Key to pop up the dialogue "Recovery will
overwrite the current system".
Select Yes button and press OK key to save, or select
NO button and press OK key to exit without saving.
2. Press red colour key to pop up the Single
Satellite Search window.
3. Press green colour key to pop up the Multi
Satellite Search window.
4. Press yellow colour key to pop up the Edit
window.
Name: User numeric keys to change the name of
the satellite, please refer to the Edit Channel Name.
Longitude: You can press keys to switch between east longitude and west
longitude. After pressing OK key, you can use numeric keys to edit the longitude, press
EXIT key or the PR+, PR- keys to exit editing mode. The range of the longitude is from 1to
180 degree. If beyond this range, system will inform you "out of range" when you press
yellow colour key on the RCU.
After setting, press yellow colour key to save and exit, while press blue colour key to exit
without saving.
To Next Page
Loading...
General