48 49
ENGLISH
If power failure occurs when When power is restored
Timer cooking (timer soaking) is
on.
The set timer will be executed.
Cooking starts immediately if the time until the set time is shorter than the guide.
Cooking (cleaning) is in process. Cooking (cleaning) continues.
Food is being kept warm. Keeping warm continues.
Gaskets will need replacing over time. Though the amount of wear will vary according to conditions of use, gaskets will
wear down as they are used. For stubborn dirt, odors, or serious damage, contact the place of purchase.
The inner pot’s uorocarbon resin coating may wear and peel with extended use. (See P.5.)
Inner pot (when scratched or cracked)
Replace the inner pot if it is cracked or the heating element is damaged.
Gaskets (consumable)
Replace the gaskets if they are dirty, smelling bad or damaged.
Plastic parts (when degraded)
The plastic parts exposed to heat and steam may degrade over time.
In case of power failure
How to purchase consumables and optional accessories
If you adjust the scorch level and keep-warm temperature, follow the procedure
below.
• You need to complete each step of to within 30 seconds.
If 30 seconds pass without operation, the procedure is canceled and the display
returns to the clock display.
In this case, start the procedure from the rst step.
• You cannot change the setting during cooking, keeping warm, timer cooking and
timer soaking.
• To cancel adjustment halfway, touch the [Cancel] key.
Adjusting to the desired scorch
If the scorch is light with high heat or dark with low heat
regardless of the setting in P.41, adjust the level of scorch in
the following procedure.
"Plain (Rinse-free)" only.
Touch the [Start/Rinse-free] key.
Touch the [Hour • Min] key to select the scorch level.
The value changes each time you touch [Hour] or [Min] key.
Touch the [Start/Rinse-free] key.
Touch and hold the [Timer] key 3 seconds or more to conrm
the setting. The display returns to the clock display.
Adjusting the keep-warm temperature
If unpleasant odor or discolored, dry, or slimy rice cannot be
solved regardless of the setting in P.42, adjust the keep-warm
temperature in the following procedure.
Touch the [Start/Rinse-free] key.
Touch the [Hour • Min] key to select the temperature.
The value changes each time you touch [Hour] or [Min] key.
Touch the [Start/Rinse-free] key.
Touch and hold the [Timer] key 3 seconds or more to
conrm the setting. The display returns to the clock display.
Touch the [Hour
•
Min] key to select the mode [1].
Touch and hold the [Timer] key 3 seconds or more.
Select "Plain".
Touch the [Hour
•
Min] key to select the mode [2].
Touch and hold the [Timer] key 3 seconds or more.
Select "Plain".
Adjusting to the desired scorch / and the keep-warm temperature
●Value adjustment
•
Scorch leve
......... -2to2
•
Keep-warm
temperature level
...... -2to2
●Mode adjustment
•
Scorch level
............ 1
•
Keep-warm
temperature level
...... 2
Blinking
Blinking
Blinking Blinking
BlinkingBlinking
Blinking
To Next Page
Loading...
