12
10.10 From the main screen, press and hold the Set button for 3 seconds,
so the day of the week you have programmed is flashing e.g. Mon
(or if you are already in the programming screen, press the Set button
once so the day flashes).
The day of the week
will flash e.g. Mon
Press and hold the Set button
for 3 seconds to show day of
the week you wish to copy
Use the Up/Down arrow
button if you wish to change
the day of the week to copy
Note:
• If no button is pressed, it will time out after 60 seconds and return to the
main screen showing day, time and output status.
• The display light will also time out after 15 seconds after the last button
is pressed
• All 6 Start time/temperature periods will need to be programmed,
unwanted Start time/temperature periods need to be entered
as the same temperature
• Unwanted days need to be entered as the same temperature (10 °C).
• The Set button can be pressed three times at any stage to exit the
programme entry mode.
Copy Function
Note:
• The copy function can only be used after you have programmed
at least one day.
To Next Page
Loading...
