35
E
TIP: The timer might be useful when you want to be alerted at
the halfway point of an activity. For example, you go out know-
ing you only have about two hours to spend on a hike. You set
the timer for 60 minutes and when it beeps you know it’s time
to turn around and start heading back to the trail head. Timer
information is not connected to Review Mode.
NOTE: While setting the timer, quickly scroll through the setting
values by holding down START/SPLIT (+) or STOP/RESET (-).
When the timer is running, a bar is shown in timer and time of
day modes above the timer icon.
If the timer is set to repeat, the bar is shown above the timer
with arrow icon.
Setting the Timer
1. Press MODE until TIMER is shown.
2. Press and hold SET to start.
3. Press START/SPLIT (+) or STOP/RESET (-) to increase or decrease set-
ting values for hours, minutes, seconds, and end action.
4. Press MODE (NEXT) to advance to the next setting option.
5. Press SET (DONE) to finish.
Operating the Timer
1. Press START/SPLIT to start the timer or restart it after a pause.
2. Press STOP/RESET to stop the countdown.
3. Hold STOP/RESET to reset the timer to the start value.
4. Hold STOP/RESET again to clear the timer to 0.
When the countdown reaches zero the watch will beep. You can press any
button to silence the beep. If you set the timer to repeat at the end of the
countdown, the repeat will continue until you press STOP/RESET. The dis-
play will show R and a number to indicate the timer is repeating and how
many times it has repeated.
34
To Next Page
Loading...
Need help?
General