9
split or a lap. The watch continues timing the next segment in the back-
ground and will display the running time again after 10 seconds.
D. Press SPLIT/RESET/SET again, to display and count the next lap. You
can count up to 99 laps in this manner.
E. When the event ends, press START/STOP. The watch will end timing.
The display will show the final lap time (LAP selected) or the total event
time (SPLIT selected).
F. Press and hold START/STOP to reset the chronograph to zero.
How to Set and Use the Countdown Timer
A. Press SPLIT/RESET to begin the setting procedure. The TENS OF
HOURS value will begin flashing in the display. Press START/ STOP to
increase setting.
B. Press MODE. The HOURS section will flash. Again, press START/STOP
to change to the desired setting. Repeat for TENS OF MINUTES,
MINUTES, TENS OF SECONDS, SECONDS. Press SPLIT/RESET/SET to
exit SET mode.
How to Use the Chronograph (Stopwatch)
A. Press START/STOP to begin timing.
NOTE: You can leave CHRONOGRAPH mode while the chronograph is
running. In TIME OF DAY mode, a stopwatch symbol on the left side of
the middle display indicates that the chronograph is running.
B. Press START/STOP to stop the timing. The chronograph will stop running.
C. Press START/STOP to resume timing, adding to time.
OR Press and hold SPLIT/RESET/SET to reset to zero.
Split or Lap Timing
A. In Chrono mode, select either SPLIT or LAP by pressing
SPLIT/RESET/SET (Note: Chrono must be at zero).
B. Begin timing (press START/STOP) as above.
C. Press SPLIT/RESET/SET to temporarily freeze the display and count the
8
To Next Page
Loading...
Need help?
General
