6
Resetting the Alarm to Come on the Next Day
1. When the alarm sounds, press the Alarm Reset/Power On/Off Button to stop the alarm sound and automatically reset
it to come on the following day.
Snooze
1. Press the Snooze/Dimmer Button after the alarm sounds; the alarm will be silenced and come on again about 9
minutes later. Snooze can be pressed several times during the 1 hour alarm cycle.
Sure Alarm
The TM-80 has a sure alarm feature. If backup batteries are installed, the buzzer alarm will still sound at the set alarm time in
the event of power failure or interruption.
Using the Alarms
Listening to your MP3/WMA files
2. Press the Play/Pause Button on the main unit or remote control to play it. The playing song’s info (iD3 tag) will show in
the bottom line of the display.
3. Press the Play/Pause Button again to pause play; press again to resume it.
4. Adjust the volume on the main unit or on the remote control.
5. Press >> or << Button on the main unit or on the remote control to go to the next or previous track.
6. To select Repeat, Random or Repeat Random play pattern, press the Settings Button as needed while a track is playing.
7. To access EQ (tone) setting mode, press and hold the Settings Button while a track is playing, then press the Settings
button to cycle through settings: Flat, Rock, Jazz, Classic and Pop. Once the desired setting is displayed, let the display
revert to the current song.
8. If you install both a Flash Drive and a SD card, press the Source Button to switch between the playing devices.
9. To turn off the unit, press the Alarm Reset/Power On/Off Button on the main unit or the remote control.
It’s easy to enjoy your digital music on the TM80. Just drag your MP3/WMA files from your computer onto your SD card or
Flash Drive (NOTE: The TM80 cannot play other file types, such as AAC, WAV, AIFF, etc. Also, the TM80 may not play some
DRM-protected files.) The TM80 is not compatible with some 3rd party software, including iTunes®.
1. Insert your SD card or Flash Drive into the TM80