Setup
11
e
n
g
Function setup
Every function setup is available by using just a single key. In on-hook status, press
X/MENU for a minimum of 3 seconds to enter the function menu. Pressing the very
same key X/MENU repeatedly will show the different functions available one after
another. Please, refer to the list below for setting up each function. You may escape
the setting menu going off-hook for a second.
Set the Language
In on-hook status, press and hold X/MENU for 3 seconds to enter LANGUAGE
SETUP. Press to select the language. Press X/MENU to confirm.
Set the Contrast
After set up the LANGUAGE, press X/MENU to access LCD CONTRAST setup.
LCD will display SETTING CONTRAST (The default setting is 3.) Press to
select the contrast (1-5). Press X/MENU to confirm.
Set Year, Date and Time
After set up the LCD CONTRAST, press X/MENU to access the YEAR, DATE and
TIME setup. The digits of the year will flash. Press to select the year.
Press X/MENU to confirm. Then digits of the month will flash. Press
to
select the month and press X/MENU to confirm. Use the same method to set up
the date and time (maybe set automatically by the network operator or PABX).
Set Ext. No. (CO-line access)
After set up the YEAR, DATE & TIME, press X/MENU to access EXT. NO. setup.
The first digit will flash. Press to select the digit and press X/MENU to
save selection. Use the same method to continue setting other digits.
When the phone is operated behind a PBX, Ext. No. can be set for dialing outside
phone numbers and a pause will be added automatically between the Ext. No. and
the phone number you dialed. E.g.: If you set up the Ext. No. as 0 and dial from the
phone book, the number stored as 0021024280 will be practically dialed as 0,
pause, 021024280 (see: Set Pause Time).
To Next Page
Loading...
