Operation
14
e
n
g
Microphone mute
In talk mode, press
and the call will be muted. If you hang up the handset the
call will be ended.
To release the mute function press
again. Microphone will be switched on.
Flash (R-key) / Transfer a call
This function is mainly for PBX systems. If you have call waiting service from your
network provider, it will also work for call waiting service.
a. Press R for call waiting service from your network provider.
b. Press R to transfer a call to another extension (within a PABX).
Note: Please, check flash timing in case of problems. PABX setting usually is 100
ms while network providers may use 100 ms or 300 ms. Please, ask your network
provider or PBX installer (in case this device is used behind a PABX) for the
appropriate setting.
Pre-dial
In on-hook status, type in the phone number and then pick up the handset. The
number will be dialed automatically.
Pause
Press / P for a break off of 1.2/2.4/3.6 seconds (depending on setting).
Redial / Auto redial
In on-hook status, press / P to review the last 16 dialed numbers.
Pick up the handset or press to dial the reviewed number.
Auto Redial
In on-hook status, press AUTO /
to auto redial the last dialed number
continuously until the phone is answered.
To Next Page
Loading...
