TIPTEL 160 - Set DTMF or Pulse Mode; Set Flash Time; Set Pause Time; Set the Ring Melodies

Setup
12
e
n
g
Set the Ring Melodies
After set up the EXT. NO., press X/MENU to access the RING MELODIES setup.
Press to select the melody (1-16) and press X/MENU to confirm.
Set the Ring Volume
After set up the RING MELODIES, press X/MENU to access the RING VOLUME
setup. Press to select the ring volume (1-8) and press X/MENU to
confirm.
Set Flash Time
After set up the RING VOLUME, press X/MENU to enter the FLASH TIME setup.
Press to select the flash time(100ms, 200ms, 300ms, 400ms, 600ms,
900ms) and press X/MENU to confirm. Please, ask your network provider or PBX
installer (in case this device is used behind a PBX) for the appropriate setting.
Set Pause Time
After set up the FLASH TIME, press X/MENU to enter the PAUSE TIME setup.
Press to select the pause time(1.2s, 2.4s, 3.6s) and press X/MENU to
confirm.
Dialing out the device will create a pause of the selected length after dialing the
digits stored in EXT. NO. (see: Set Ext. No.). This pause time will be used when
pressing P or using the telephone book accordingly.
Set DTMF or Pulse Mode
After set up the PAUSE TIME, press X/MENU to access the DTMF or PULSE
MODE setup. Press to select the mode(DTMF or PULSE) and press
X/MENU to confirm.
Please, ask your network provider or PBX installer (in case this device is used
behind a PBX) for the appropriate setting.
It is possible to temporarely switch from pulse to DTMF (tone dialing) mode during
a call pressing * .