ED655 3
Safety precautions
sheet and technical information to ensure safe use.
never be sprayed or pumped back into a container with a
arise. The container must be earthed.
HAZARD: HAZARDOUS VAPORS
Paints, solvents, and other materials can be harmful
if inhaled or come in contact with body. Vapors can
cause severe nausea, fainting, or poisoning.
PREVENTION:
instructions supplied with the mask to be sure it will provide
the necessary protection.
vapors must be observed.
are necessary for the protection of the skin. Observe the
regulations of the manufacturer concerning coating materials,
solvents and cleaning agents in preparation, processing and
cleaning units.
HAZARD: GENERAL
This product can cause severe injury or property
damage.
PREVENTION:
governing ventilation, re prevention, and operation.
holding the spray gun. The recoil force of the spray gun is
particularly powerful when the tip has been removed and
a high pressure has been set on the airless pump. When
cleaning without a spray tip, set the pressure control knob to
the lowest pressure.
risks and liabilities when using parts that do not meet the
minimum specications and safety devices of the pump
manufacturer.
safe handling of paint and solvents.
slip hazard.
children or anyone not familiar with the operation of airless
equipment.
disposed of in an environmentally friendly way.
1.2 Electric Safety
Electric models must be earthed. In the event of an electrical short
circuit, earthing reduces the risk of electric shock by providing an
escape wire for the electric current. This product is equipped with
a cord having an earthing wire with an appropriate earthing plug.
Connection to the mains only through a special feed point, e.g.
DANGER — Work or repairs at the electrical
equipment may only be carried out by a skilled
electrician. No liability is assumed for incorrect
installation. Switch the unit o. Before all repair
work, unplug the power plug from the outlet.
Danger of short-circuits caused by water ingressing into the electrical
pressure steam cleaners.
Work or repairs at the electrical equipment:
assumed for incorrect installation.
Operating Temperature
This equipment will operate correctly in its intended ambient, at a
Relative Humidity
The equipment will operate correctly within an environment at 50%
Measures shall be taken by the Purchaser to avoid the harmful eects
of occasional condensation.
Altitude
This equipment will operate correctly up to 2100 m above mean sea
level.
Transportation and Storage
This equipment will withstand, or has been protected against,
It has been packaged to prevent damage from the eects of normal
humidity, vibration and shock.
To Next Page
Loading...
Need help?
General
