EN
27
In more detail...
Operation
EN
26
Fig. 10
Bevel planing
With the V-groove (27) bevel angles of 45° can be cut on the edge of a workpiece.
1. Place the V-groove (27) onto the edge of the workpiece (Fig. 11).
2. Guide the product along the edge.
45°
27
Fig. 11
NOTE: Apply slight consistent pressure against the workpiece to
achieve an even result.
WARNING! Danger of kickback! Apply the product to the workpiece
only when switched on!
Standard surface planing with or without the parallel guide
1. Set the desired cutting depth. It is best to use small depths of cut and repeat
the planing process (Fig. 12).
2. Attach the parallel guide (10) if required to the product as described above
and adjust to desired width.
3. Place the product laterally to the workpiece and guide the product along the
edge (Fig. 13).
Fig. 12 Fig. 13
TTB876PLN by TITAN
To Next Page
Loading...
Need help?
General
