15
5. If I change some of the setting on the app while the APP OVERRIDE dial is set to ON,
what will happen when I switch the dial to APP OVERRIDE to OFF?
It depends on the variable. If the variable is included on the control board, then once
APP OVERRIDE is turned off, then the variable will go back to the settings on the control
board. If the variable in question is not available to adjust on the control board, when the
APP OVERRIDE switch is set to OFF, the variable will still carry the values as set on the
APP.
6. What do the limit switches do?
The limit switches help make you gate open and close more smoothly. By setting the
limit positions, the gate will know to slow down once the position is reached, making
sure that your gates opens and closes as silently as possible.
7. How to tell if the fuse is blown?
The fuse can be removed by pulling. By holding the transparent fuse to the light, you can
see the wire in between. If the wire is no longer there or connected, then the fuse has
been blown. A backup fuse is included on the control board, as shown in the diagram
below. Remove the backup fuse and exchange it with the one that is blown. If you need
additional fuses, please contact customer support.
8. Why is my POWER LED ashing?
If the POWER LED is ashing, then it means that the system has not yet nished learning.
At this stage, the operator will not function until learning has been completed.
To Next Page
