Toa IP-450D - Specifications

13. SPECIFICATIONS
Printed in Japan
133-12-645-1A
• Accessories
Fiber washer ................................................. 4
Screw 5 x 20 ................................................ 4
Screw M4 x 20 ............................................. 4
Power cord (2 m) .......................................... 1
Instruction manual ........................................ 1
IP-300D IP-450D IP-600D
300 W 450 W 600 W
200 W 300 W 400 W
600 W 900 W 1200 W
20 Hz – 20 kHz (+0 dB, –0.5 dB)
0.01%
0.1%
+ 2.2 dB (1.00 V) ±0.5 dB + 4.0 dB (1.23 V) ±0.5 dB + 5.3 dB (1.42 V) ±0.5 dB
32 dB
10 kΩ (electrically-balanced)
110 dB
Under 40°C : Stop
40°C – 75°C : Low to high speed (variable)
Over 75°C : High speed
Input (CH1, CH2) : XLR-3-31, XLR-3-32, balanced phone jack
Output : Terminal with screw/washer assembly
CONTROL I/O : 8P DIN
Power supply : AC inlet
POWER (green), SIGNAL x 2 (green), PEAK x 2 (red), PROTECT x 2 (red), VR BYPASS x 2 (yellow)
230 VAC ±10%, 50/60 Hz
430 VA 660 VA 940 VA
1200 VA 1800 VA 2400 VA
Panel : Zinc diecasting, black paint
Case : Colored steel plate, black
482 (w) x 102.4 (h) x 473.5 (d) mm
13 kg 18 kg
Model No.
Output 20 Hz – 20 kHz
STEREO RL=4 Ω
RL=8 Ω
BTL RL=8 Ω
Frequency Response
Total Harmonic Distortion
8 Ω, 1 kHz
8 Ω, 20 Hz – 20 kHz
Input Sensitivity
(8 Ω, input level control in maximum position)
Voltage Gain
Input Impedance
Signal-to-Noise Ratio
20 Hz – 20 kHz
Cooling Fan Speed
Connection Terminal
Indicator
Power Source
Power Consumption
Based on UL/CSA standards
4 Ω, rated output
Finish
Dimensions
Weight
[Notes]
• 0 dB = 0.775 Vrms
• The above specifications are subject to change without notice.