Need help?Do you have a question about the Toa KD-1 and is the answer not in the manual?
Details on the KD-1's designed operation on local AC (50/60Hz) Mains, ±10%.
Describes the wiring standard for XLR connectors: pin 1 ground, pin 2 cold, pin 3 hot.
Explains the 48V DC phantom power switch on channel 1 for condenser microphones.
States that descriptions are based on Toa's usage and manufacturer variations.
Adjusts low frequency response (±15dB at 20Hz shelving) with a flat response at '0'.
Adjusts high frequency response (±15dB at 20kHz shelving) with a flat response at '0'.
Controls the balance between Reverb and external Effect signals in the mix buss.
Determines the amount of reverb and effect signal returned to the system mixing buss.
Indicates green for power on, red for thermal protection or fuse activation.
Provides variable adjustment of channel output to the mixing busses for level setting.
Determines the overall volume level of the KD-1 system output.
Accepts stereo headphones, providing the same signal as the speaker output.
Lights when the internal compressor is activated to protect the speaker system.
1/4" phone jack for connecting outboard effects devices to the KD-1.
1/4" phone jack for sending signals to outboard effects devices from the KD-1.
Unbalanced RCA pin input jack with a nominal level of -30dB.
Unbalanced 1/4" phone jack with a nominal input level of -20dB.
Standard unbalanced 1/4" phone jack; switches out RCA input when used.
Alternately turns phantom power (48V DC) on/off for the Channel 1 XLR connector.
Three-position switch; middle position is 'off'. Select position for lowest system hum.
Three-wire type with grounding. Do not remove ground pin; use adapter if needed.
Unbalanced RCA pin jacks for pre-fader signals to tape recorders.
Slide switch providing 30dB attenuation for 1/4" and RCA input jacks.
Electronically balanced connector for Channel 1, with phantom power support.
Slide switches to connect/disconnect individual channel signals to the effect buss.
Warning on fuse replacement: use same type/rating. Disconnect from AC before changing.
1/4" phone jack for external speaker connection; switches off internal speaker.
To Next Page
General
