Contents
Precautions .................................................................................. 1
General Description ....................................................................... 2
Features ...................................................................................... 2
Front Panel: Names of components & their usage ............................... 3
Rear Panel: Names of components & their usage ................................. 4
Block and Level Diagrams .............................................................. 5
Specifications ........................................................................... 5~6
Appearance .................................................................................. 6
Precautions
1. Power Supply
The KD-1 is designed to operate on local AC (50/60Hz) Mains, ±10%.
2. XLR Type Audio Connector
The connectors are wired as follows.
The pin 1 is ground (shield), the pin 2 cold (low, minus), the pin 3 hot (high, plus).
3. Phantom Power Supply
The phantom power switch on channel 1 input permits the user to supply 48V DC
through the input connector to a condenser microphone. If phantom power is not
required, the switch must be in the "off" position.
4. Description of components and functions of the KD-1
Various descriptions are applied, depending on each manufacturer. In our
Operating and Instruction Manual explanation of components and functions is
made according to Toa's usage for them.
1
To Next Page
Loading...
