TOELLNER TOE 9261 - Signal Line Switch Attenuation Data; TOE 9261 Protection Function Specifications; TOE 9261 Connector Specifications

Section 4 – Technical Data
TOELLNER Electronic Instrumente GmbH
19
(Technical data, cont.)
Attenuations for signal line switches
Blocking attenuation
With 100 Ω system impedance
8 kHz / -40 dB
Bandwidth
With 100 Ω system impedance
38 MHz / -3 dB
Protection functions
Overcurrent or short-circuit of the switching paths
Monitoring
Reaction
Reset
Continuous current and peak current
Switching off of switching paths, display OVL
Switching off and on again using mains switch
Input current
Monitoring
Reaction
Reset
Averaging of the inductive energy supplied per switching
operation from the supply line to the device input
Switching off of switching paths, display OVL
Switching off and on again using mains switch
Note: The incoming energy can be minimized by a short cable,
arranged for low-inductance.
Max. switching frequency exceeded
Monitoring
Reaction
Reset
Frequency present at the control input
Switching off of switching paths, display OVL
Reduction in the switching frequency below the permissible
value with consideration of a hysteresis of typically 5 kHz
Excessive temperature
Monitoring
Reaction
Reset
Temperatures of the power components
Stage 1: Increase in fan speed
Stage 2: Switching off of switching paths, display OVL
Switching off and on again using mains switch following
appropriate cooling period
Power switch is not reverse polarity protected!
Reverse polarity voltage applied to the input or output can
damage the unit from excess current or thermal overload.
Connections
Mains voltage
Appliance plug. Voltage range see “General”
Control input
Rated voltage range and impedance
Trigger threshold
Protective circuit / overvoltage range
Impedance outside the rated voltage range
1x BNC, unearthed, at front
1x BNC, unearthed, at rear
-0.5 … 5.5 V / 1 MΩ
< 2 V (compatible with TTL, CMOS 5V and LVCMOS 3.3V)
Self-resetting fuse / protection up to ± 20 V
> 1 kΩ
Power switch
Input sockets Plus – Minus
High-current socket pair 6 mm red / blue, with touch protection
Output socket OUT
High-current socket 6 mm gray, with touch protection
Second pair of sockets Plus – Minus
High-current socket pair 6 mm red / blue, with touch protection
Signal line switches
Inputs/outputs
Front side connector for connecting screw terminal blocks with
3.81 mm spacing
Matching screw terminal blocks are e.g.:
Phoenix MC 1.5 / 4-ST-3.81 = Article No. 1803594
Würth Elektronik plug-in cable system WR-TBL Series 361
= Article No. 691361300004
Electrical isolation
Between power switch, signal line switches, control input and
PE, max. 42 V
peak
each