INSPECTION AND MAINTENANCE70
10
4. Install the upper oil plug, and then
remove oil tube nozzle and install the
lower oil plug.
ENOW00095-0
Do not reuse oil plug gasket. Always use
new gasket and tighten oil plug properly to
prevent entry of water into lower unit.
ENOW00928-0
Wipe off gear oil well immediately if spilled
and dispose of it in accordance with local
fire prevention and environment protection
regulations.
ENON00032-0
Note
If water in the oil, giving it a milky colored
appearance. Contact your dealer.
ENOM00086-A
Propeller replacement
ENOW00084-0
z Do not begin propeller removal and
installation procedure with spark plug
caps attached, shift in forward or
reverse, main switch at other than
“OFF”, engine stop switch lock attached
to the switch, and starter key attached,
or engine could accidentally start lead-
ing to serious personal injury. Discon-
nect battery cable if possible.
z The propeller edge is thin and sharp.
Wear the groves during replacement to
protect your hands.
ENOW00086-0
z Do not install propeller without thrust
holder, or propeller boss could be dam-
aged.
z Do not reuse split pin.
z After installing split pin, spread the pin
apart to prevent it from falling out which
could lead to the propeller coming off
during operation.
A worn-out or bent propeller will lower the
motor's performance, and cause engine
trouble.
CAUTION
CAUTION
ENOF01333-0
ENOF01331-0
WARNING
CAUTION
To Next Page
