19
INSTALLATION
4
②
Connect the positive lead (+) to the
positive terminal (+) of the battery,
and then connect the negative
lead (−). When disconnecting
the battery always remove the
nega tive lea d (− ) fir st. Aft er
connecting the positive terminal
(+), securely place a cap on it to
prevent short circuits.
●
Make sure that the battery leads do
not get stuck between the outboard
motor and boat when turning, etc.
●
The starter motor may fail to
operate if the leads are incorrectly
connected.
●
Be sure to correctly connect the (+)
and (−) leads. If not, the charging
system will be damaged.
●
Do not disconnect the battery leads
from battery while the engine is
operating, the electrical parts could
be damaged.
●
Always use a fully charged battery.
!
Battery cord
(black)
Battery cord
(red)
Do not use a battery that is not
recommended. Use of a battery
not recommended can lead to poor
performance of, and/or damage to, the
electrical system.
!
!
Battery generates explosive hydrogen
gas. Be sure to:
●
Charge the battery in a well-
ventilated place.
●
Place the battery away from any
source of fire, sparks and open
flames such as burners or welding
equipment.
●
Do not smoke when handling the
battery.
●
Do not smoke near the battery when
the battery is charging.
Note
Minimum recommended battery : 12V,
70AH (800 Marine Cranking Amps
(MCA) or 650 Cold Cranking Amps
(CCA))
Specifications and features of batteries
vary among the manufacturers. Consult
the manufacturer for details.
OM_E_MFS15C-20C_body_111224.indd 19 11/12/13 12:40
To Next Page
Loading...
