TOHATSU MFS 15C - Removing and Carrying the Outboard Motor; Removing the Outboard Motor; Carrying the Outboard Motor; Storing the Outboard Motor

44
REMOVING AND CARRYING THE OUTBOARD MOTOR
7
①
Stop the engine.
②
Disconnect the fuel connector,
the remote control cables and the
battery cords from the outboard
motor.
③
Remove the outboard motor from
boat and completely drain the
water from the gear case.
Keep the outboard motor in a vertical
position when carrying.
!
WARNING
●
Close air vent screw of fuel tank and
fuel cock before carrying or storing
outboard motor and fuel tank, or fuel
may leak, potentially catching fire.
●
Do not give a shock to an outboard
motor durin g t ransp or tatio n. It
becames a cause of breakage.
3. Storing the outboard motor
Outboard motor should be stored in a
vertical position.
1. Removing the outboard motor
2. Carrying the outboard motor
Do not carry or store outboard motor in
any of positions described below.
Otherwise, engine damage or property
damage could result from leaking oil.
!
CAUTION
Engine may be hot immediately after
operating and could cause burns if
touched. Allow Engine to cool down
before attempting to carry the outboard.
!
CAUTION
Note
If the outboard motor must be laid
down be sure the tiller handle faces
down as shown in the drawing above.
Elevate power unit 2 inches to 4
inches if traveling to avoid oil spillage.
REMOVING AND CARRYING THE OUTBOARD MOTOR
OM_E_MFS15C-20C_body_111224.indd 44 11/12/13 12:40