INSPECTION AND MAINTENANCE74
10
ENOM00096-A
Fuel filter (for fuel tank)
Water or dirt in the fuel tank will cause
engine performance problems.
Check and clean the tank at specified
times or after the outboard motor has
been stored for a long period of time
(over three months).
1. Remove four screws to remove the
Fuel Pick-Up.
2. Clean the fuel filter and replace the
gasket.
3. Reassemble all parts.
1. Fuel pick-up
2. Filter
ENOM00098-A
Gear oil replacement
ENOW00094-0
z Be sure that outboard motor is secured to
transom or service stand, or accidental
drop or fall of outboard motor could lead
to severe personal injury.
z Be sure to lock outboard motor if it is
tilted up, or accidental fall of outboard
motor could lead to severe personal
injury.
z Do not go under outboard motor tilted up
and locked, or accidental fall of outboard
motor could lead to severe personal
injury.
1. Tilt down the outboard motor.
2. Remove the oil plugs (lower and
upper), and completely drain the gear
oil into a pan.
3. Insert the oil tube nozzle into the
lower oil plug hole, and fill with gear
oil by squeezing the oil tube until oil
flows out of the upper plug hole and
bubbles is disappeared to remove the
air.
2
1
ENOF00926-A
WARNING