INSPECTION AND MAINTENANCE 75
10
ENON00033-0
Note
Use genuine gear oil or the recommended
one (API GL-5: SAE #80 to #90).
Required volume: approx. 360 mL (11.8
fl.Oz).
4. Install the upper oil plug, and then
remove oil tube nozzle and install the
lower oil plug.
Oil plug specified tightening torque:
4N·m (3 ft
·lb, 0.4 kgf·m)
ENOW00095-0
Do not reuse oil plug gasket. Always use new
gasket and tighten oil plug properly to pre-
vent entry of water into lower unit.
ENOW00928-0
Wipe off gear oil well immediately if spilled
and dispose of it in accordance with local
fire prevention and environment protection
regulations.
ENON00032-0
Note
If water in the oil, giving it a milky colored
appearance. Contact your dealer.
ENOM00086-A
Propeller replacement
ENOW00084-0
z Do not begin propeller removal and instal-
lation procedure with spark plug caps
attached, shift in forward or reverse,
main switch at other than “OFF”, engine
stop switch lock attached to the switch,
and starter key attached, or engine could
accidentally start leading to serious per-
sonal injury. Disconnect battery cable if
possible.
z The propeller edge is thin and sharp. Wear
the groves during replacement to protect
your hands.
CAUTION
CAUTION
WARNING
To Next Page
Loading...
Need help?
General
