Tohnichi CEM3-G-BTA Series - Parity setting; Communication format setting

25/35
xviii. Parity (Default: NONE)
Select the parity from EVEN, ODD or NONE. Match it with your PC setting.
Prt
NONE
Prt
ＯＤＤ
Ｐｒｔ
ＥＶＥＮ
Select the parity using upper or down arrow keys. Press “MEM” key to save setting and
go to next. Press “MD” key to skip setting and go to next. Press “C” key to go back to
RUN mode (measurement mode).
xix. Communication format (Default: M-3)
Select the communication format. It affects the data strings for communication. Refer
the “7.3. Communication format” for details.
dCn
M-3
dCn
M3+ID
※
When change the communication format setting the measured data would be
cleared.
Select the communication format using upper or down arrow keys. Press “MEM” key to
save setting and go to next. Press “MD” key to skip setting and go to next. Press “C”
key to go back to RUN mode (measurement mode).
dCn
CLR_OK
dCn
CLEAR