Tohnichi CEM3-G-BTA Series - 9. Data output and clear; 9.1. Batch measurement data output

29/35
9. Data output and clear
9.1. Batch measurement data output
i. Set the counter number to the upper end that you need using ▲▼ keys, then press “MD”
key to the next
ii. Set the number on right display to the lower end that you need using ▲▼ keys then
press “MD” key to the next
Example 1) To output data 001 to 200
Set counter to 200 and press “MD” key. Confirm STT shows 1 and press “MD” to the next
Example 2) To output data 101 to 200
Set counter to 200 and press “MD” key. Set STT number to 101 and press “MD” to the next
iii. The right display shows the number of data to output. Press “MD” key to output batch
data or press “C” key to go back to measurement mode