Tohnichi CEM3-G-BTA Series - 9.3. Data clearance; 9.3.1. Delete a single data; 9.3.2. Delete the selected range of data

33/35
9.3. Data clearance
9.3.1. Delete a single data
i. Set the counter number to be deleted
ii. Press "C" key to delete
・ The example display if there is no Hi/ Lo limit torque setting
・ The example display if there are Hi/ Lo limit torque settings
9.3.2. Delete the selected range of data
i. Set the counter number to the upper end that you delete using ▲▼ keys, then press
“MD” key to the next
ii. Set the number on right display to the lower end that you delete using ▲▼ keys then
press “MD” key to the next