34/35
Example 1) To delete data 001 to 200
Set counter to 200 and press “MD” key. Confirm STT shows 1 and press “MD” to the next
Example 2) To delete data 101 to 200
Set counter to 200 and press “MD” key. Set STT number to 101 and press “MD” to the next
Example 3) To delete all data
Set counter to 999 and press “MD” key. Confirm STT shows 1 and press “MD” to the next
iii. Press "MD" key and "C" key at the same time when the left display shows either "N",
"MAX", "MIN" or "AVE" such as the following example displays. Then release both
keys.
iv. After deletion completed display back to the lower end counter and back to
measurement mode
・ The example display if there is no Hi/ Lo limit torque setting
・ The example display if there are Hi/ Lo limit torque settings
The selected data deletion completed
To Next Page
Loading...
