Tohnichi CEM3-G-BTA Series User Manual

6/35
3. Explanation of each mode
The CEM3-G-BTA has two modes that are Measurement mode and Display mode
3.1. Measurement mode
 Inspection mode (MODE-M)
MODE-M is used for the re-tightening and breakaway inspections. If you set the
high and low limit torque values the tool makes judgment the measured torque
result.
The double tightening detection feature will be off while MODE-M. When you set the
high and low torque values under MODE-M the display shows "M" on the left display
as below.
 Tightening mode (MODE-T)
MODE-T is used for tightening process. When you set the high/ low torque and
angle, double tightening detection angle, and direction of tightening, the tool gives
the beep intermittent and blue LED if the torque value reaches about 80% of low
limit torque. Once reaches on low limit torque value the tool give beep continuous
and red LED. When you set high and low limit torque under MODE-T the left display
shows "T" as below.
3.2. Display mode
 RUN mode (The counter is “000”)
The display shows the torque value being applied at the moment and returns to zero
when torque is released. When the angle setting is on, left display shows angle
value as well as. When you rotate to CW the angle is positive and to CCW it is
negative values.
 Peak mode (The counter is “001” to “999”)
The maximum torque will be captured and the display holds it. When the low or high
limit torque values are set, the low limit value is shown on left upper corner of left
display, the high limit value on right of the left display.
When the trigger torque is set and torque reach on it the angle is measured. The
angle value has positive when to rotate to CW and angle has negative when to
CCW. The display holds maximum angle value even if the torque is released.

Tohnichi CEM3-G-BTA Series Specifications

General

Brand	Tohnichi
Model	CEM3-G-BTA Series
Category	Measuring Instruments
Language	English