Tokheim ProGauge MAGLINK LX - Connecting the RF Receiver (for XMT-SI-RF)

MAGLINK LX Installation Manual | Connections
Rev. 09,
– April 2016 Page 14 of 24
6.3 Connecting the RF Receiver (for XMT-SI-RF)
The image below shows how to connect your console to an RF Receiver:
The receiver connects directly to connector CN7 without going through the intrinsically safe barrier.
In this case the barrier remains unused.
Connection
Specifications
CN7
Not used - Terminal 5
White (-0 V) - Terminal 4
Blue (RS485B) - Terminal 3
Brown (RS485A) - Terminal 2
Red (+ 12V) - Terminal 1
For proper connections of the receiver, you must refer to the installation manual of the RF Receiver
(Section on electrical connections).