MAGLINK LX
Installation Manual
| Introduction
Rev. 09,
– April 2016
Page 4 of 24
3
I
NTRODUCTION
The present manual has been prepared in accordance with IEC 82079-1 standards. “Preparation of
instructions for use - Structuring, content and presentation - Part 1: General principles and detailed
requirements”and according to the ATEX Directive 2014/34/EU concerning equipment and protective
systems intended for use in potentially explosive atmospheres.
The manual provides all necessary information about installing the Maglink LX console.
ATTENTION: This manual must be used in conjunction with the following manuals:
• Console Configuration
• User Manual
To use the console, you must install the console as described in this manual, configure the
console as a reference manual, and use the console on the field as reference manual
The Maglink LX console complies with the requirements of Directive 2012/19/EC on waste of electrical and
electronic equipment (WEEE) and hence displaying the according symbol:
IMPORTANT: The crossed out wheelie bin symbol indicates that the product, at the end of its
useful life, must be disposed of with household waste and must be brought to a collection
point for electrical and electronic equipment
The following table lists reference data of the manufacturer:
Data Description
Name START ITALIANA S.r.l.
Address
Via Pola 6
20813 Bovisio Masciago (MB)
Italia
Telephone +39 0362 1581465
Fax +39 0362 1581464
Website www.startitaliana.it
e-Mail assistenza@startitaliana.it
The following table lists the symbols used in the document:
Symbol Description
ATTENTION: Important information and notes regarding operations and use
considerations
IMPORTANT: Danger to persons (including death), to property or to the
environment
ATTENTION: The units of measurement contained in this manual refer to a specific choice
by the user himself/herself. You can set the measurement units in a different way (see
Section 6.1 of this manual).
To Next Page
Loading...
