Tokheim ProGauge MAGLINK LX - Modem Connection; DVD Connection

MAGLINK LX Installation Manual | Connections
Rev. 09,
– April 2016 Page 16 of 24
The following table lists the console connectors and the meaning of the different LEDs present:
Connector
Specifications
SV1
Modem connector/IFSF (optional)
LED1
Power LED output to probe
L1
Relay 2 status LED (Lit:
relay energised)
L2
Relay 3 status LED (Lit: relay energised)
L3
Relay 4 status LED (Lit: relay energised)
L9
Input 6 status LED (Terminal 7)
L10
Input 5 status LED (Terminal 6)
L11
Input 4 status LED (Terminal 5)
L12
Input 3 status LED (Terminal 4)
L13
Input 2 status LED (Terminal 3)
L14
Input 1 status LED (Terminal 2)
L19
Relay 1 status LED (Lit: relay energised)
6.5 Modem Connection
Connection of the GSM modem
Basic operations:
1. Disable the PIN code from the SIM card before insert it into the modem.
2. Insert the SIM card into the dedicated slot of the modem
3. Power on the console and wait some time to allow to the modem to
connect to the GSM network. When connected the GSM signal depth will
appear on the display of the console.
6.6 DVD connection
DVD has CAN bus communication and has to be connected to CN1
The power supply has to be bypassed through relay nr. 4 since the Maglink LX will power the DVD only
when it is necessary activating or deactivating the relay nr. 4.
When DVD is configured Relay nr.4 is not available for any alarm settings