Operation Manual
12
3.4. Changing remote control channel.
When two or more units of the TCP-2000 systems are used in the same room, a
device failure may occur due to interference if the same remote control channels
are used. In such case, set different channels for each remote control. There are 3
remote control channels available.
The remote control channel must be set for both the remote and the main unit.
To change remote control channel please press following buttons at one time.
Please keep button pressed until main unit will confirm channel change with three
beeps.
PRG + LAMP/OFF + F1 to select channel no 1.
PRG + LAMP/OFF + F2 to select channel no 2.
PRG + LAMP/OFF + F3 to select channel no 3.
Removing batteries from remote control will reset its current
channel setting. It will be automatically set to channel no 1. If
different channel was used before please perform channel
selection procedure. Otherwise main unit will not respond to
remote control commands.
Remote control channel is immediately changed when three
buttons are pressed at one time. Main unit will change its
channel only if you keep those buttons until you get three beeps
conformation.
Channel 1 is Default factory setting.
WARNING !
WARNING !
WARNING !
To Next Page
Loading...
