Tomey TCP-2000 - Exiting Menu; Shutdown System

Operation Manual
26
• Colour modification effect is visible on two square
polygons displayed in bottom right corner of the screen.
• It is recommended to adjust only RED compound value for
the red polygon (colour mask) and only GREEN compound
for the green polygon.
• Depending on Phoropter setting in the configuration menu
you are adjusting panel colours for phoropter or colour
glasses only.
To adjust colour intensity to the required level select with Arrow up/down button
required colour compound, then press right Arrow to begin edition of the intensity.
To modify colour value use up and down Arrow button. To accept and store the
value press Arrow left.
4.14. Exiting Menu
Select ‘Exit (SETUP)’ using Arrow Up or Arrow Down button.
1. Press Right Arrow to exit Service Menu. TCP-2000 will return to the last
displayed test. Changes implemented will be saved after Chart Panel is
turned off.
2. You can exit Service mode by simply pressing ‘SETUP’ button. TCP-
2000 will return to the last displayed test. Changes implemented will be
saved after Chart Panel is turned off.
3. You can also exit from MENU using ‘ESC’ button. In this case changes
implemented will be saved only until Chart Panel is turned off.
Each time you would like to return to higher level of Configuration Menu please
select „Exit (SETUP)” and press the right Arrow or at any time SETUP button.
4.15. Shutdown system
Select ‘Shutdown system’ using Arrow Up or Arrow Down button.
1. Press Right Arrow. Following screen will appear :
• Press ‘OK’ button to restart application.
• Press ‘F3’ button to shut down system.
• Press ‘ESC’ button to cancel.
WARNING !