Operation Manual
19
4.10. Phoropter
Set this option to ‘Yes’ when you use TCP-2000 Chart Panel together with
phoropter. Adjust colours ( see chapter 4.13.5. ) to assure interpretability with the
phoropter colour filters.
1. Select ‘Phoropter’, using Arrow Up or Arrow Down button.
2. Press Right Arrow to edit mode.
3. Use Up and Down Arrows to set edited parameter to ‘Yes’ or ‘No’ value.
4. Press Left Arrow to apply changes.
4.11. User defined programs - PROGRAM 1, PROGRAM 2,
PROGRAM 3.
TCP-2000 Chart Panel allows the user to define his own programs. Each program
is a sequence of up to 20 steps of charts, tests or eye anatomy pictures available
from the panel. Masks and colour filters can be used in combination with charts.
You can store 3 programs, each 20 steps long.
4.11.1. Programming Mode
To define your own program follow step 1 to 4:
1. Choose program you would like to edit using Arrow Up or Arrow Down.
2. Press Right Arrow, to enter Programming Mode.
Now you can start building your program sequence. Select test you want to add to
current program (picture, tests or masks). To confirm your selection and add step
to the program press ‘F1’ button. Device will signal with message ‘ Item added to
program, Press any key to continue’ each properly added step of the program.
3. Press ‘F2’ after program step has been stored to end programming process
and store selected test into the memory of the chart panel.
Device will signal end of programming sequence with message ’Programming
finished’.
You can enter Menu at any moment and change settings, e.g. children tests, chart
type, etc.
To Next Page
Loading...
