Tomey TL-100 - Method of Operation; Preparation for Operating

3-1
3. METHOD OF OPERATION
3.1 Preparation for operating
• Before turning on the power, check the following items:
- Make sure that the cover glass under the nose piece is clean.
- Make sure that the nose piece seated properly.
- Make sure a lens is not on the nose piece.
1) Connect the female end of the power cord into the power terminal on
the back of the TL-100 and the male end into a 3-prong power
outlet.
2) Turn the power switch ON.
3) The initial screen will appear for approximately five seconds.
Nose piece
Cover glass
3.1 PREPARATION FOR OPERATING
H
O
L
D