Mounting LINK 300/310
15
EN
1. Choose a flat surface for accurate
positioning of the unit.
2. Clean the surface with the provided
cleaning tissue, so that the surface is oil
free, dry and clean.
3. Remove the protective film from one side
of the strips.
4. For dashboard mounting (see figure) stick
the strips to the bottom side. For
windscreen mounting stick the strips to the
top side.
5. Remove the protective films from the other
side of both strips.
6. Place the unit with the adhesive strips on
the prepared surface. Press it gently for a
few seconds until it sticks.
Note: The full strength of the strips will be reached
after approx. 72 hours depending on the
temperature.
IG_EN.book Page 15 Friday, June 10, 2011 3:26 PM
To Next Page
Loading...
Need help?
General
