Conrm that the pressure is displayd as “0 MPa”.
Conrm that the power supply switch is set to ON.
Conrm that the operation or completion indication
lamp on the control panel is not illuminated or
blinking respectively.
Press the lid lock releasing pedal while slightly
pushing down the lid handle of the main unit.
Pull up the lid gently while holding the lid handle of
the main unit.
<
Opening the chamber lid
>
①
②
③
④
⑤
Pull down the lid while holding the lid handle of the main unit.
Place the hands on the lid handle of the main unit and push it down until the open lid
indication lamp goes out.
<
Closing the chamber lid
>
①
②
※
The chamber lid may not close easily when the temperature in the chamber is high, immediately
after operation etc. In such a case, close the lid after the temperature falls.
To Next Page
Loading...
