5-10. Removing sterilized articles
Do not open the chamber lid until the pressure falls to 0 MPa.
●
Contravention is dangerous with likelihood of death or serious accident due
to blowout emanating from sterilized articles or steam when the lid is opened
while a raised pressure remains.
Be extremely careful of steam emanating from the inside of the
chamber when opening the chamber lid.
●
Contravention is dangerous with likelihood of scalds or injury because steam
emanating from the inside of the chamber is extremely high in temperature.
Be careful of high-temperature liquid because it may boil suddenly.
●
The temperature of liquid falls more slowly than that of the chamber and
liquid may boil because of a trigger such as physical shock. When liquid is
not dealt with carefully, there is likelihood of scalds or unexpected accident.
Do not leave the inside of the chamber or sterilizing water
contaminated.
●
Contravention is dangerous with likelihood of corrosion or damage to the
chamber. In addition, the water level sensor may malfunction and reduce the
empty heating prevention function, which may result in fire in case of empty
heating.
Conrm that the pressure is displayd as “0 MPa”.
Conrm that the completion indication lamp on the work monitor is blinking or illuminated.
Open the chamber lid.
Remove sterilized articles.
※
Do not hit articles to be sterilized on the lid gasket when placing or removing the articles to be
sterilized.
The damage and deection on the lid gasket may cause the steam leakage.
Clean the inside of the chamber or sterilizing water when they are contaminated.
※
Refer to “8.Preventive maintenance”.
①
②
③
④
⑤
Pay extreme caution when removing sterilized articles as they are
very hot.
●
Immediately after autoclaving, sterilized articles can become very hot and
must be handled with extra care, otherwise cause a serious burn injury or
accident.
To Next Page
Loading...
